Sony XVS-7000 Users Guide - Page 144
Modifying a wipe pattern edge Edge, Carrying out a color mix for the edge fill, matte, Border
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
Modifying a wipe pattern edge (Edge) You can apply a border to the pattern or soften the edges. Border Applies a border to the pattern. Soft Softens the pattern edges. Soft Border Softens the border applied to the pattern. When a border or soft border is selected, the signal filling the edge is called an edge fill. For the edge fill, you can use a signal (matte) generated by a dedicated color matte generator, or the signal selected on the utility 2 bus. A matte has two colors, color 1 and color 2, which can be combined (color mix). 1 Open the M/E-1 >Wipe >Edge/Direction menu (1154). 2 In the group, select the edge type. 3 Depending on the selection in step 2, set the following parameters. When [Border] is selected No. Parameter Adjustment 1 Width Border width When [Soft] is selected No. Parameter Adjustment 1 Soft Edge softness When [Soft Border] is selected No. Parameter Adjustment 1 Width Border width 2 Inner Soft Degree of softness inside the border No. Parameter Adjustment 3 Outer Soft Degree of softness outside the border 4 When Border or Soft Border is selected, select the edge fill signal in the group. Utility 2 Bus: Signal selected on the utility 2 bus Matte: Signal from a dedicated color matte generator 5 Depending on the selection in step 4, carry out the following operation. When [Utility 2 Bus] is selected: On the cross-point control block, press delegation button [UTL2] on the cross-point pad and select a signal using the cross-point buttons. Notes • On the cross-point control block in key/AUX bus delegation mode, press the [UTIL2] button in the 1st row and select a signal using the cross-point buttons in the 2nd row. • You can assign the utility 2 bus using the [UTIL] button on the cross-point pad of the cross-point control block (see page 79). • You can assign a utility 2 bus delegation button to the 1st row or 2nd row of the AUX bus control block (AUX bus operation mode) in the Setup menu (see page 417). When [Matte] is selected: Press [Matte Adjust] to open the Matte Adjust menu (1154.1), and select [Flat Color] (single color) or [Mix Color] (2-color mix) in the group. If [Mix Color] is selected, set the color mixing (see page 144). If [Flat Color] is selected, set color 1 using the following parameters. No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Hue Hue Carrying out a color mix for the edge fill matte If [Matte] is selected for the border or soft border edge fill, you can combine color 1 and color 2. To combine colors, you can use not only a normal wipe generator pattern, but also a dedicated color mix pattern. 1 In the group of the M/E-1 >Wipe >Edge/ Direction menu (1154), select [Matte] and press [Matte Adjust]. 144