Sony XVS-7000 Users Guide - Page 263

No. Parameter Adjustment 1 Defocus V Degree of defocusing of the video signal 2 Defocus K Degree of defocusing of the key signal To turn the afterimage portion into stardust The afterimage portion becomes stardust, and gradually disappears. 1 In the DME >Light/Trail >Trail menu (4152), press [Dust], turning it on. 2 Set the following parameters. No. Parameter Adjustment 1 Trail Dust Amount of the afterimage disappearing as stardust a) 2 Dust Soft Timing with which stardust disappears 3 Dust Size Size of stardust 4 Dust Aspect Aspect ratio of stardust a) The way in which the afterimage disappears is affected by both the trail [Decay] and [Trail Dust] parameter adjustments. Setting a combine process Select whether to add the Trail effect before or after the combine. Notes • When you change the selection in the group, the afterimages which had been added up to then disappear. • When you do not combine images, the Trail effect only is applied, regardless of the selection in the group. In the group of the DME >Light/Trail >Trail menu (4152), select one of the following. Combine −> Trail: Add the Trail effect after the combine. The parameter data for the channel with the lowest number among the channels being combined is enabled. Trail −> Combine: Add the Trail effect before the combine. Parameters can be set independently for each channel. Combine −> Trail Trail −> Combine Motion Decay Settings Note Enabling Motion Decay automatically disables Trail, Keyframe Strobe, or Wind if it is set. Applying the Motion Decay effect 1 Open the DME >Light/Trail >Motion Decay menu (4153). 2 Press [Motion Decay], turning it on. 3 Set the following parameter. No. Parameter Adjustment 1 Video Decay Degree of decay of the video signal a) a) 0.00 represents no afterimage. 100.00 represents no decay in the afterimage. 4 In the group, select the way in which the video signal is blurred. Soft: Mix the live image and the afterimage. Hard: Show the brighter parts of the live image and afterimage. Erasing the afterimages that remain in memory whenever a keyframe is passed In the DME >Light/Trail >Motion Decay menu (4153), press [Decay Eraser], turning it on. When the effect passes a keyframe, the afterimage is erased before writing a new afterimage. Selecting the freeze timing In the group of the DME >Light/ Trail >Motion Decay menu (4153), select the timing for freezing motion decay. Frame: Freeze in frame units. 263