Sony XVS-7000 Users Guide - Page 470
Setting a Link Between M/E Banks, Setting Key Transition Links, Setting a Color Corrector Link Group
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 470 highlights
To release the link In the Engineering Setup >Switcher >Link >Internal Bus Link menu (7336.1), select a link number and press [Clear]. Setting a link table 1 In the Engineering Setup >Switcher >Link >Internal Bus Link menu (7336.1), select the target link number to set. 2 Press [Link Table Select]. The Link Table Select menu (7336.3) appears. The bottom of the status area shows a list of the selected link table signals. 3 Select the link source and link destination signals. No. Parameter Adjustment 4 Main No Video/key signal for link source 5 No Video/key signal for link destination 4 Press [Link Src Set]. To initialize the link table setting Press [Init Link Table], check the message, then press [Yes]. To select another link table Select the link table number using the following parameter, and press [Link Table Set]. No. Parameter Adjustment 3 Link Table Link table number No Setting a Link Between M/E Banks The operations which can be linked are as follows. • Transition execution (auto transition, cut, and fader lever operation) • Next transition selection • Transition type selection 1 In the Engineering Setup >Switcher >Link menu (7336), press [M/E Link]. The M/E Link menu (7336.6) appears. The status area shows the link number list on the left and a list of the switcher banks (M/E or P/P) that can be selected on the right. 2 Select the target link number to set. 3 In the group, select [Master M/E] (link source). 4 Select the M/E or PGM/PST link source, then press [M/E Set]. 5 In the group, select [Linked M/E] (link destination). 6 Select the M/E or PGM/PST link destination, then press [M/E Set]. To also link operations other than transition execution Press [Transition Only], turning it off. To release the link Select the link number and press [Clear]. Setting Key Transition Links The operations which can be linked are as follows. • Auto transition • Key on/off 1 In the Engineering Setup >Switcher >Link menu (7336), press [Key Trans Link]. The Key Transition Link menu (7336.7) appears. The status area shows the link number list on the left and a list of the keys that can be selected on the right. 2 Select the target link number to set. 3 In the group, select [Master Key] (link source). 4 Select the key for the link source, and press [Key Set]. 5 In the group, select [Linked Key] (link destination). 6 Select the key for the link destination, and press [Key Set]. To release the link Select the link number and press [Clear]. Setting a Color Corrector Link Group You can configure an AUX bus color corrector link group. 1 In the Engineering Setup >Switcher >Link menu (7336), press [Aux Bus CCR Link]. The Aux Bus CCR Link menu (7336.8) appears. 470