Sony XVS-7000 Users Guide - Page 393

Settings Relating to System Configuration Selecting the Operation Mode You can set the switcher system operation mode to the following three modes. Single Proc mode: A single control panel controls a single switcher (including DMEs). Dual Simul mode: A single control panel controls two switchers (including DMEs) simultaneously. This allows operation to continue on one switcher if the other switcher cannot communicate due to device failure or other cause. Region Simul mode: A single control panel controls a single switcher (including DMEs) and regions of another switcher (including DMEs) simultaneously. The target regions to control are set in the Region Simul Config menu (7312.3). Notes • To enable region simultaneous control using Region Simul mode, press the button assigned with the "Region Simul Enable" utility command. When region simultaneous control is disabled, the operation is the same as Single Proc mode. • Before region simultaneous control is enabled, the region selection status of both switchers must be the same. Execute a snapshot, for example, to set the same status. 1 In the group of the Engineering Setup >System >System Config menu (7312), select the operation mode. Single Proc: Single Proc mode Dual Simul: Dual Simul mode Region Simul: Region Simul mode To select the Dual Simul mode setup target Select the setup target switcher for Dual Simul mode in the group. To set SWR1, select [System1]. To set SWR2, select [System2]. To set both switchers simultaneously, select both [System1] and [System2]. To clear the setting Press [Clear]. 2 Press [Execute]. 3 Check the message, then press [Yes]. Setting the regions to control in Region Simul mode 1 In the Engineering Setup >System >System Config menu (7312), press [Region Simul Config]. The Region Simul Config menu (7312.3) appears. 2 Select the target regions to control. M/E-1 to M/E-5, P/P, User1 to User8, and DME1 to DME4 regions can be selected. Press the buttons for the regions to control, turning them on. Specifying the Switcher Controlled by the Control Panel 1 In the status area of the Engineering Setup >System >System Config menu (7312), select the target control panel to set. 2 Specify the switcher to control. If there is only one switcher on the network: In the group, select [SWR1] or [SWR2]. In the group, disable both [SWR1] and [SWR2]. If there are two switchers on the same network: In the group and group, select the switchers. When the operation mode is set to [Dual Simul], the status of the switcher set in the group appears on the control panel. 3 To set the selected control panel as the tally control master panel, press [Tally Master], turning it on. If there are multiple control panels and switchers, the control panel on which [Tally Master] is enabled performs tally control for the whole system. Notes • When there are multiple control panels, make sure that one of them has [Tally Master] enabled. • If the master panel is changed, be sure to copy and save the setup tally (TLY) and router (RTR) data in the File menu, and make the same settings on another panel. • If the master panel tally data is loaded into a panel with a different unit ID, then [Tally Master] is disabled. • [Tally Master] cannot be enabled on the 4th control panel (PNL4). 393