Sony XVS-7000 Users Guide - Page 104

Setting the independent key transition rate (utility/shotbox control block and numeric keypad control block) If the independent key transition mode is set to [Independ], setting the transition rate while a key is not inserted will set the transition rate for key insertion, and setting the transition rate while a key is inserted will set the transition rate for key removal. 1 Press the [TRANS RATE1] to [TRANS RATE3] buttons in the utility/shotbox control block. This switches the memory recall buttons to transition rate display mode. For details about the [TRANS RATE1] to [TRANS RATE3] buttons, see "Setting the transition rate (utility/shotbox control block and numeric keypad control block)" (page 92). 2 Press a memory recall button displaying the transition rate to set for the target key, turning it on. The region name and transition rate appears in the numeric keypad control block display. 3 Enter the transition rate using the numeric keypad in the numeric keypad control block. You can switch the input mode using the [TC] button. In frame input mode, enter three digits. In timecode input mode, enter four digits. To clear the entered value, press the [CLR] button. 4 Press the [ENTER] button. The input is applied, and the specified value is reflected in the memory recall button in the utility/ shotbox control block. To enter a difference value To set the transition rate by specifying a difference value from the current value, press the [+/−] button, enter the difference value, and press the [TRIM] button. Each time you press the [+/−] button, it toggles between plus (+) and minus (-). To check the independent key transition rate The specified independent key transition rate is displayed in the independent key transition display section in the transition control block or independent key transition control block. The transition rate for keys assigned to the key delegation buttons are shown on the display in the key fader control block. You can also switch the utility/shotbox control block to transition display mode to check the transition rate set for each key. For details about the transition rate display mode, see "Frame display mode and timecode display mode" (page 91). Setting the independent key transition rate (menu) This section describes setting the transition rate of key 1 on the M/E-1 bank as an example. 1 Open the M/E-1 >Key1 >Transition/Video Process menu (1117). 2 Select the transition type in the group. If the independent key transition mode is set to [Independ], select the transition type for key insertion in the group and the transition type for key removal in the group. 3 Set the transition rate. No. Parameter Adjustment 1 Transition Transition rate Rate To display the independent key transition rates in list view and change the settings You can display the transition rate, independent key transition rate, and fade-to-black transition rate for each bank, and change the settings (see page 189). 104