Sony XVS-7000 Users Guide - Page 230

Softening the border edges 1 In the Border/Crop menu (4111), press [Border Soft], turning it on. 2 Set the following parameter. D Key signal for cropping the image within the border Set the same shape as the inner contour of the border image key signal. No. Parameter Adjustment 1 Soft Softness of inner edge of border The CG border using these signals is rendered as follows. CG Border Settings This sets the CG border for the selected DME channel. Using two DME channels enables you to change the position and size of the image embedded in the border. Notes • This setting is available only when the signal format is 1080i. • The CG border cannot be set if the DME channel is used for the combiner function. • CG border settings on DME channel 2 or 4 are available only when the key and DME channel for the CG border are not assigned in the Engineering Setup >Switcher >Config >CG Border Int Video Channel Assign menu (7331.15). • A CG image video signal must be input on Ext In of channel 1 (or channel 3) and a CG image key signal must be input on Ext In of channel 2 (or channel 4) beforehand. The following four signals are required for a CG border. A Border image Set the background of the border image to black. B Border image key signal C Image to be embedded within the border Adding a CG border (without changing the position/size of the image) The operation can be performed for each DME channel, however, channels 1 and 2 and channels 3 and 4 will have the same effect. 1 Open the DME >Edge >Border/Crop menu (4111). 2 In the group, press [CG Border], turning it on. Adding a CG border (changing the position/size of the image) To change the position and size of the image embedded in the CG border, use two DME channels. The combination of the two DME channels to use is channels 1 and 2 or channels 3 and 4 only. The keys and DME channels for the CG border must be configured in the Setup menu beforehand. For details about key and DME channel settings, see "Setting the Keys and DME Channels used in a CG Border" (page 442). Assigning DME channels to keys Assign the DME channels for the CG border configured in the Setup menu to the target keys. Assigning one of the two DME channels will automatically assign the other channel. For details about key assignment operations, see "Assigning a DME to a key" (page 121) and "Assigning a DME to a key" (page 128). Notes • It is not possible to assign only one of the DME channels. • It is not possible to assign one of the DME channels if either of the channels is in use. 230