Sony XVS-7000 Users Guide - Page 111

5 Make the following settings as required. To invert the black and white of the key source: Press [Key Invert], turning it on. To adjust the horizontal position or key source width for a luminance key, linear key, color vector key, or chroma key: Press [Key Position], turning it on, and set the following parameters. No. Parameter Adjustment 1 H Phase Key horizontal position 2 Left Key left edge position 3 Right Key right edge position To set the key priority: Press [Key Priority] to open the M/E-1 >Misc >Key Priority menu (1173), and set the priority (see page 87). Selecting Key Fill and Key Source Selecting the key fill and key source 1 Open the M/E-1 >Key1 >Type menu (1111). 2 In the group, select the key fill. Key Bus: Signal selected on the key 1 fill bus Matte: Signal from a dedicated color matte generator 3 If [Key Bus] is selected in step 2, select a key fill signal using one of the following methods. • On the cross-point control block, press delegation button [KEY1] on the cross-point pad and select a signal using the cross-point buttons. • On the cross-point control block in key/AUX bus delegation mode, press the [KEY1] button in the 1st row and select a signal using the cross-point buttons in the 2nd row. Note You can assign a key fill bus delegation button to the 1st row or 2nd row of the AUX bus control block (AUX bus operation mode) in the Setup menu (see page 417). 4 If [Matte] is selected in step 2, press [Matte Adjust] to open the Matte Adjust menu (1111.2), and select [Flat Color] (single color) or [Mix Color] (2-color mix) in the group. If [Mix Color] is selected, set the color mixing (see page 112). If [Flat Color] is selected, adjust color 1 using the following parameters. No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Hue Hue 5 In the group, specify the key source selection mode. Self: Selects the key fill bus signal. Auto Select: Automatically selects the key fill signal on the cross-point buttons and the signal assigned with it as a pair. Split: Allows you to select a separate signal that the signal that would be selected automatically. Notes • When chroma key is selected as the key type, select [Self]. • When [Split] is selected, the key memory function is disabled. 6 If [Split] is selected in step 5, select a key source signal using one of the following methods. • On the cross-point control block, press and hold delegation button [KEY1] on the cross-point pad and select a signal using the cross-point buttons in the 2nd row. • Press and hold the [SPLT] button in the key control block, then select a signal using the cross-point buttons in the 2nd row in the cross-point control block. • On the Flexi Pad control block in key operation mode, press and hold the [KEY1] button in the memory recall section and select a signal using the cross-point buttons in the 2nd row in the cross-point control block. • On the cross-point control block in key/AUX bus delegation mode, press and hold the [KEY1] button in the 1st row and select a signal using the crosspoint buttons in the 2nd row. When a cross-point button is pressed, a key signal is selected. To select a video signal, first set the [KEY] button operation mode in the Setup menu (see page 112). Notes • On the cross-point control block in key bus mode or free assign mode, you can select a key fill signal in the 1st row and a key source signal in the 2nd row by pressing and holding the following buttons. - Key bus delegation buttons on the cross-point pad - [SPLT] button on the key control block 111