Sony XVS-7000 Users Guide - Page 391
Configuring input/output, Configuring network synchronization, Setting NMOS, Multicast, Mixed
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 391 highlights
12 Check the message, then press [Yes]. Configuring input/output You can enable/disable the hitless failover function for each board. You can also set the audio format for each input/output. 1 In the group of the Engineering Setup >System >Network Config menu (7311), press [Input/Output]. The Input/Output menu (7311.5) appears. 2 In the group, select the target switcher to set. The status area shows the slot number and input/output settings status. 3 In the status area, select the target slot in which the board is installed. 4 Enable or disable hitless failover. You can configure hitless failover for each board. To enable, press [Hitless Fail Over], turning it on. To disable, press [Hitless Fail Over], turning it off. Note The same setting is applied to both inputs and outputs when an XKS-C9121 is installed. 5 In the status area, select the target input/outputs to set. 6 Set the audio format of the input/outputs. Press [Audio Format], and select an audio format from the pop-up window. The following formats (sampling frequency/packet time/number of channels) are supported. • 48kHz/0.125ms/2ch, 4ch, 8ch, 16ch • 48kHz/1ms/2ch, 4ch, 8ch 7 Repeat steps 3 to 6 as required. 8 Press [Execute]. 9 Check the message, then press [Yes]. Configuring network synchronization You can set network synchronization (Genlock) for each main network and sub network. 1 In the group of the Engineering Setup >System >Network Config menu (7311), press [Genlock]. The Genlock menu (7311.6) appears. 2 In the group, select the target switcher to set. The status area shows the slot number and network settings status of the main and sub networks. You can check the following information. Genlock: Network synchronization enable/disable Domain: Domain Com Mode: Communication mode 3 In the status area, select the target network to set. 4 Enable/disable network synchronization. To enable, press [Genlock], turning it on. To disable, press [Genlock], turning it off, and skip to step 7. 5 Press [Domain], turning it on, and set the domain using the following parameter. No. Parameter Adjustment 4 Domain Domain (0 to 255) 6 In the group, select the communication mode. Multicast: Multicast Mixed: Combination of multicast and unicast 7 Repeat steps 3 to 6 as required. 8 Press [Execute]. 9 Check the message, then press [Yes]. Setting NMOS The XKS-C8111/XKS-C9111/XKS-C9121/XKS-C8166 support NMOS (Networked Media Open Specifications). To manage operations using NMOS, configure the IP address and port number of the RDS server on each board. Note Enabling NMOS will disable the LSM settings in the IP Address menu (7311.2). 1 In the group of the Engineering Setup >System >Network Config menu (7311), press [NMOS]. The NMOS menu (7311.7) appears. 2 In the group, select the target switcher to set. The status area shows the slot number and NMOS settings status. 391