Sony XVS-7000 Users Guide - Page 159

Basic DME Wipe Setting Operations You carry out DME wipe setting operations using the DME Wipe menu for each bank. This section describes operations on the M/E-1 bank (M/E-1 >DME Wipe menu) as an example. For details about independent key transition DME wipe settings, see "Basic Independent Key Transition DME Wipe Setting Operations" (page 164). Note You can display the input image filling the frame when executing a DME wipe by disabling the edge softness function in the Setup menu. For details, see "Setting the DME Wipe Edge Softness Function" (page 467). Selecting a DME Wipe Pattern 1 Display the DME wipe setting menu. In 1-channel mode, open the M/E-1 >DME Wipe >1ch menu (1161). In 2-channel mode, open the M/E-1 >DME Wipe >2ch menu (1162). In 3-channel mode, open the M/E-1 >DME Wipe >3ch menu (1163). 2 Press the button for the desired DME wipe pattern group to select it. The patterns from the selected pattern group appear on the screen. If executing a DME wipe using a resizer Select [Resizer Slide], [Resizer Squeeze], or [Resizer Frame I/O] in the DME wipe pattern group. Resizer DME wipes can be used only when the next transition event is a key. 3 Press the desired pattern to select it. Adjusting DME wipe pattern parameters Of the DME wipe patterns, the following have parameters that can be adjusted. Note In an independent key transition, DME wipe pattern parameters cannot be configured. When Squeeze (for one channel) is selected (pattern numbers 1032, 1033) When Crop Slide (for two channels) is selected (pattern numbers 2661, 2662) No. Parameter Adjustment 1 Holding Level Position for entering the dead band a) 2 Tolerance Width of the dead band a) Set relative to a transition start point of 0% and end point of 100%. When Page Turn (for one channel) is selected (pattern numbers 1301 to 1313, 1315 to 1318, 1341 to 1345) When Page Turn (for two channels) is selected (pattern numbers 2701 to 2713, 2715 to 2718, 2741 to 2745) When Roll (for one channel) is selected (pattern numbers 1321 to 1333, 1335 to 1338, 1346 to 1350) When Roll (for two channels) is selected (pattern numbers 2721 to 2733, 2735 to 2738, 2746 to 2750) No. Parameter 1 Radius 2 Magnitude 3 Start Angle Adjustment Radius of the turned page flap a) Angle of rotation through course of transition b) Angle at start of transition b) a) 0% is an effect like a turned page, 100% is normal curl, and 200% is radius with double the normal curl. b) The angle of rotation range varies depending on the pattern. -100.00 is rotation in the counterclockwise direction, +100.00 is rotation in the clockwise direction, and 0.00 is no rotation. When Brick (for two channels) is selected (pattern numbers 2801 to 2804, 2811 to 2814) No. Parameter Adjustment 1 Side V Size X Horizontal scaling factor 2 Side V Size Y Vertical scaling factor 3 Height 4 Center X 5 Center Y Height of brick Horizontal center position a) Vertical center position b) a) The horizontal center position of the video pasted on Side V. At -100.00, the center is at the left edge of the screen. At +100.00, the center is at the right edge of the screen. b) The vertical center position of the video pasted on Side V. At -100.00, the center is at the bottom edge of the screen. At +100.00, the center is at the top edge of the screen. 159