Sony XVS-7000 Users Guide - Page 160
Setting DME Wipe Modifiers, Setting the background image, Specifying the DME wipe direction, Direction
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 160 highlights
When Frame I/O (for two channels) is selected (pattern numbers 2851 to 2854) No. Parameter 5 Delay Adjustment Timing for video selected on a utility bus to appear on the screen When Frame I/O (for two channels) is selected (pattern numbers 2861 to 2864) No. Parameter 1 Rot X 2 Rot Y 3 Rot Z 5 Delay Adjustment Rotation on the Y axis (horizontal direction) Rotation about the X axis (vertical direction) Rotation about the Z axis Timing for video selected on a utility bus to appear on the screen When Brick (for three channels) is selected (pattern number 3601) Parameter group [1/2] No. Parameter Adjustment 1 Side V Size X Side V horizontal scaling factor 2 Side V Size Y Side V vertical scaling factor 3 Height Height of brick a) 4 Side V Center X Side V horizontal center position b) 5 Side V Center Y Side V vertical center position c) a) Common with the [Height] parameter in group 2. b) The horizontal center position of the video pasted on Side V. At -100.00, the center is at the left edge of the screen. At +100.00, the center is at the right edge of the screen. c) The vertical center position of the video pasted on Side V. At -100.00, the center is at the bottom edge of the screen. At +100.00, the center is at the top edge of the screen. Parameter group [2/2] No. Parameter Adjustment 1 Side H Size X Side H horizontal scaling factor 2 Side H Size Y Side H vertical scaling factor 3 Height Height of brick a) 4 Side H Center X Side H horizontal center position b) 5 Side H Center Y Side H vertical center position c) a) Common with the [Height] parameter in group 1. b) The horizontal center position of the video pasted on Side H. At -100.00, the center is at the left edge of the screen. At +100.00, the center is at the right edge of the screen. c) The vertical center position of the video pasted on Side H. At -100.00, the center is at the bottom edge of the screen. At +100.00, the center is at the top edge of the screen. Setting the background image When the switcher signal format is 3840×2160P 2SI, you can set a color signal to use as the background of DME wipes. Note When the signal format is other than 3840×2160P 2SI, the image selected on the utility 2 bus is used. 1 In the M/E-1 >DME Wipe >Edge/Direction menu (1164), press [DME Bkgd Matte Adjust]. The Matte Adjust menu (1154.1) appears. 2 In the group, select one of the following. Flat Color: Use a single color signal. Set the following parameters. No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Hue Hue Mix Color: Use a mix color signal. For details about color mix settings, see "Carrying out a color mix for the edge fill matte" (page 144). Note The color signal for the background image of DME wipes is shared with the color matte settings for wipe edge fills. Setting DME Wipe Modifiers You can apply various modifiers, such as setting the wipe direction or the pattern position. For an overview of modifiers and supported pattern numbers, see "DME Wipe Pattern Variation and Modifiers" (page 157). Specifying the DME wipe direction (Direction) You can specify the DME wipe direction (normal/reverse). To specify the wipe direction in the menu 1 Open the M/E-1 >DME Wipe >Edge/Direction menu (1164). 160