Sony XVS-7000 Users Guide - Page 339

To execute an assigned action This section describes assignment of bank 1 to the 1st row for utility/shotbox operation as an example. 1 Press the delegation button [UTL/SB 1] on the cross- point pad. Use the [UTL/SB 1] button for the 1st row. 2 Press the cross-point button with the registered action you want to execute in the 1st row. • For actions that enable/disable a function, the selected button is lit amber, and the function is enabled. To disable the function, press the button again. • For other actions, the function for the selected button is executed. Shotbox Overview A shotbox is a function that is used to save any combination of snapshots or keyframe effects specified for a region in memory (shotbox register) and then recall them simultaneously as required. There are 99 shotbox registers on each control panel. The diagram above shows the settings in the 99 shotbox registers, conceptually. Each register may contain any combination of target region with the snapshots or effects to be recalled. The Auto Run function is an attribute which can be set for each register. When enabled, an effect recalled by executing a shotbox operation is automatically executed. • When register 1 is executed, this recalls M/E-1 snapshot 1, User2 effect 5, and DME ch2 effect 1. Auto run is enabled for register 1, hence User2 and DME ch2 effects are executed at the same time they are recalled. • When register 3 is executed, M/E-1 effect 1, P/P effect 90, and User1 effect 1 are recalled. Auto run is disabled for register 3, hence you must press the [RUN] button in the utility/shotbox control block to execute the effects. 339