Sony XVS-7000 Users Guide - Page 252

To limit the direction in which modulation is applied Press [Plus Only], turning it on. You can limit the direction in which modulation is applied (the direction in which the image expands) to the plus direction only. To set the ripple center position 1 Press [Position]. 2 Set the following parameters. No. Parameter Adjustment 1 H Ripple center point in horizontal direction 2 V Ripple center point in vertical direction To limit the ripple range 1 Press [Range], turning it on. 2 Set the following parameters. When [Radial] or [Shape] is selected in the group No. Parameter Adjustment 1 Size R Modulation level of ripple along radius 2 Offset R Center of modulation range along radius When [Angular] is selected in the group No. Parameter Adjustment 1 Size A Modulation level of ripple along circumference 2 Offset A Center of modulation range along circumference When [Both] is selected in the group No. Parameter Adjustment 1 Size R Modulation level of ripple along radius 2 Offset R Center of modulation range along radius 3 Size A Modulation level of ripple along circumference 4 Offset A Center of modulation range along circumference To reverse the ripple range When [Radial], [Both], or [Shape] is selected in the group, press [Range Rev R], turning it on. When [Angular] or [Both] is selected in the group, press [Range Rev A], turning it on. Other settings You can configure [Lock], [Form], [Random], and [Range Envelope]. The operation is the same as [Lock], [Form], [Random], and [Range Envelope] in the Wave menu (4141.1). For details, see "Wave Settings" (page 248). Rings Settings You can set the degree of transition, the degree of randomness in the distance moved by each block, the amount of movement, the width of the partitions, the degree of randomness in partition width, the center point, the starting angle, and other parameters. To apply the Rings effect 1 Open the Non Linear >Rings menu (4141.7). 2 To make transition settings, press [Transition] and set the following parameters. No. Parameter Adjustment 1 Transition Degree of transition 2 Random Degree of randomness in distance moved by each block 3 Spiral Amount of movement toward circumference accompanying transition 3 To set the partition method, press [Partition] and set the following parameters. No. Parameter Adjustment 1 Width Width of partition 2 Random Degree of randomness in partition width 3 Angle Starting angle of effect 4 To set the ring center position, press [Position] and set the following parameters. No. Parameter Adjustment 1 H 2 V Center point in horizontal direction Center point in vertical direction 5 To partition into pixels, press [Pixel], turning it on, and set the following parameters. No. Parameter Adjustment 1 Density Degree to which image disappears around periphery 252