Sony XVS-7000 Users Guide - Page 117
When drop border or shadow is selected, When emboss is selected, Utility 1 Bus, Matte
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
No. Parameter Adjustment 3 Density Density • When separate edge is enabled The left, right, top, and bottom border or outline widths can be adjusted independently. The separate edge function is only available when luminance key, linear key, color vector key, or chroma key is selected as the key type. No. Parameter Adjustment 1 Top Top edge width 2 Left Left edge width 3 Right Right edge width 4 Bottom Bottom edge width 5 Density Density When drop border or shadow is selected No. Parameter Adjustment 1 Width Width 2 Position Position 3 Density Density When emboss is selected No. Parameter Adjustment 1 Width Width 2 Position Position 3 Density a) Density a) The Density adjustment only affects the key edge. This can be adjusted separately from key Density, and if key Density is set to 0.00, only the embossed edge effect can be applied. If emboss is selected, adjust the edge fill in step 6. 4 In the group, select the edge fill signal. Utility 1 Bus: Signal selected on the utility 1 bus Matte: Signal from dedicated color matte generator. When [Matte] is selected, adjust color 1 using the following parameters. No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Hue Hue When the edge type is outline, in place of the edge fill signal, the selected key fill signal fills the outline, and the background fills all areas other than the outline. 5 Depending on the selection in step 4, carry out the following operation. When [Utility 1 Bus] is selected: On the cross-point control block, press delegation button [UTL1] on the cross-point pad and select a signal using the cross-point buttons. Notes • On the cross-point control block in key/AUX bus delegation mode, press the [UTIL1] button in the 1st row and select a signal using the cross-point buttons in the 2nd row. • You can assign the utility 1 bus using the [UTIL] button on the cross-point pad of the cross-point control block (see page 79). • You can assign a utility 1 bus delegation button to the 1st row or 2nd row of the AUX bus control block (AUX bus operation mode) in the Setup menu (see page 417). When [Matte] is selected: Press [Matte Adjust] to open the Matte Adjust menu (1112.1), and select [Flat Color] (single color) or [Mix Color] (2-color mix) in the group. If [Mix Color] is selected, set the color mixing (see page 118). If [Flat Color] is selected, adjust color 1 using the following parameters. No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Hue Hue 6 If the edge type is emboss, adjust the color in the group. When adjusting color 1 and 2, select [Matte 1] and [Matte 2], respectively, then adjust the following parameters. No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Hue Hue 7 To soften the edge, select [Soft Edge] and set the following parameter. No. Parameter Adjustment 1 Soft Edge softness Note When normal is selected for edge type, [Key Drop] must be enabled beforehand to use [Soft Edge]. 117