Sony XVS-7000 Users Guide - Page 461
Setting an Output Format Converter, Setting the format converter conversion, method
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 461 highlights
Switcher signal format 3840×2160P (Level A, SQD) 1080P (Level A) 1080i 720P Output signal format • 3840×2160P (Level A, 2SI) • 3840×2160P (Level B, 2SI) • 3840×2160P (Level A, SQD) a) • 3840×2160P (Level B, SQD) • 1080P (Level A) a) • 720P b) • 1080i a) • 720P • 576i c) • 480i c) • 1080i • 720P a) • 576i c) • 480i c) a) Output signal without format conversion b) Selectable when the 720P converter is enabled c) When the switcher signal format frequency is 59.94, only 480i is selectable. When the frequency is 50, only 576i is selectable. 1 In the Engineering Setup >Switcher >Output menu (7333), press [Internal FC]. The Internal FC menu (7333.15) appears. 2 Press [FC Format]. The FC Format menu (7333.17) appears. The status area shows the FC channel list on the left and the supported conversion signal format list on the right. 3 In the list on the left, select the target FC channel to set. Select one of the four target channels or eight target channels to set. 4 In the list on the right, select the signal format. 5 Press [Set]. To clear the signal format setting Press [Clear]. 6 Press [Execute]. Setting the format converter conversion method You can set the format converter conversion method for each FC channel. The conversion method items and the target conversion formats are given below. Item Enhancer Up-converter aspect ratio Down-converter aspect ratio I/P converter conversion mode Up-converter conversion mode Conversion format • 3840×2160P (Level A, 2SI) t 1080P (Level A) • 3840×2160P (Level A, 2SI) t 1080P (Level B) • 3840×2160P (Level A, 2SI) t 1080i - • 1080i t 576i • 1080i t 480i • 720P t 576i • 720P t 480i • 1080i t 720P - In the Engineering Setup >Switcher >Output >Internal FC menu (7333.15), press [FC Adjust] to open the FC Adjust menu (7333.6). The operation is the similar to setting format converter inputs. For details, see "Setting the format converter conversion method" (page 447). Setting an Output Format Converter You can set an output format converter for outputs of the following output connector boards. • XKS-S9167 12G-SDI Output Board • XKS-C9121 100G IP Input and Output Board Notes • On the XVS-8000/7000/6000, output format converters are not available. • The XKS-C9121 has the following restrictions. - This setting is available only when the switcher signal format is 3840×2160P 2SI or 1080P. - When the switcher signal format is 3840×2160P 2SI, an output format converter can be configured on only the 1st & 2nd and 9th & 10th outputs of each board. - When the switcher signal format is 1080P, an output format converter can be configured on only the 1st to 4th and 9th to 12th outputs of each board. • When an XKS-C9121N NMI Input and Output Board is installed, an output format converter can be configured, but conversion formats other than "3840×2160P (Level A, 2SI)" are not supported. Setting the conversion format You can set the signal format of outputs to convert by the format converter. 461