Sony XVS-7000 Users Guide - Page 133
Setting cropping device control block, Setting the border menu
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
Setting cropping (device control block) You can adjust the crop width of the top/bottom/left/right edges in the device control block (trackball). Note The [BDR/CROP] button must be assigned to the operation buttons beforehand in the Setup menu (see page 411). 1 Enable the resizer as described in steps 1 to 3 in "Reducing, enlarging, rotating, and moving keys (device control block)" (page 131). 2 In the M/E-1 >Key1 >Resizer >Border/Crop menu (1115.1), press [Crop], turning it on. 3 In the device control block, press and hold the [SHIFT] button, and press the [BDR/CROP] button, turning it on green. 4 Select the target edge to crop, and adjust the crop width using the Z-ring. Select the target edge to crop by pressing the following buttons. • [X] button: Crop width of top edge • [Y] button: Crop width of left edge • [Z] button: Crop width of right edge • [CTR] button: Crop width of bottom edge The target bank and resizer, and the current parameter and its value, are displayed in the display of the device control block. The edge parameters are indicated by the letter "T" (top edge), "L" (left edge), "R" (right edge), and "B" (bottom edge). For details about parameter operations, see "ThreeDimensional Parameter Entry" (page 227). Notes • Pressing the [FINE] button, turning it on, enables fine adjustment of setting values (fine mode). • If no target edge to crop is selected, operating the Zring adjusts the crop width of all edges. • For cropping, the number of significant digits of the parameter after the decimal point is two. Setting the border (menu) 1 In the M/E-1 >Key1 >Resizer menu (1115), press [Resizer], turning it on. 2 In the group, press [Border/ Crop]. The Border/Crop menu (1115.1) appears. 3 Press [Border], turning it on. 4 Set the following parameters. No. Parameter Adjustment 1 H Simultaneously adjust border width of left and right edges 2 V Simultaneously adjust border width of top and bottom edges 3 All Simultaneously adjust border width on all edges 4 Density Border density To apply color to a border 1 In the group, press [Flat Color]. 2 Set the following parameters. No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Hue Hue To soften the inner edge of a border 1 Press [Border Soft]. 2 Set the following parameter. No. Parameter Adjustment 1 Inner Soft Softness of inner edge of border To add a beveled light edge 1 In the group, press [Beveled Light Edge]. 2 Set the following parameters. No. Parameter Adjustment 1 Top Position of top side 2 Left Position of left side 3 Right Position of right side 4 Bottom Position of bottom side 5 All Position of all four sides 3 If setting the softness of the border, press [Border Soft], turning it on. 4 Set the following parameters. 133