Sony XVS-7000 Users Guide - Page 135

• The CG border settings are saved separately in key 1 and key 2 key snapshots. When recalling, it is necessary to recall the two key snapshots at the same time. Four signals are required for a CG border. The image to embed in the border and the key signal for keying the image must be selected using key 1 in advance. The border image and the key signal for the image must be selected using key 2. For details about signals used in a CG border, see "CG Border Settings" (page 230). 1 In the M/E-1 >Key1 >Resizer menu (1115), press [Resizer], turning it on. 2 In the group, press [Border/ Crop]. The Border/Crop menu (1115.1) appears. 3 In the group, press [CG Border], turning it on. 4 Set the position and size of the image to embed in the border using the following parameters. No. Parameter Adjustment 1 Location X Horizontal position 2 Location Y Vertical position 3 Size Size To lock the border setting You can lock the position and size of the border image of the CG border. In the group, press [Frame Pos Lock] to lock the border. Note Locking the border returns all resizer parameters to their default values, and the settings cannot be changed. Effect Settings Restrictions on resizer effects Restrictions on the use of effects Of the resizer effects, using mask, drop shadow, or wide key border requires two resizer hardware units. These are called "dual resizer effects." In a dual resizer effect, predetermined combinations of key 1 and key 2, key 3 and key 4, key 5 and key 6, key 7 and key 8 are used. For example, if the resizer is enabled on either key 1 or key 2, the other key cannot be used for a dual resizer effect. The same restriction applies when using a resizer DME wipe in place of resizer. There are also restrictions on the combination of effects that can be used simultaneously on the same keyer. Unavailability of simultaneous use within the same keyer The following combinations of resizer effects cannot be enabled simultaneously. • Mosaic and edge enhance • Defocus and wide key border • Mask and drop shadow • Mask and wide key border Resizer effects setting menu 1 In the M/E-1 >Key1 >Resizer menu (1115), press [Resizer], turning it on. 2 In the group, press [Enhanced Effect]. The Enhanced Effect menu (1115.2) appears. Setting a wide key border 1 In the M/E-1 >Key1 >Resizer >Enhanced Effect menu (1115.2), press [Dual Rszr Effect], turning it on. 2 Press [Wide Key Border], turning it on. 3 Set the following parameters. No. Parameter Adjustment 1 H Simultaneously adjust border width of left and right edges 2 V Simultaneously adjust border width of top and bottom edges 3 All 4 Soft a) Simultaneously adjust border width on all edges Softness of border 5 Density Border density a) Common to the [Soft] drop shadow parameter. 4 To add an outline, press [Outline], turning it on. 5 To adjust the border color, press [Border Color]. 6 Set the following parameters. No. Parameter Adjustment 1 Luminance Luminance 135