Sony XVS-7000 Users Guide - Page 85

For details about double-press operation settings of the [BKGD] button, see "Setting the Button and Fader Lever Operation Mode" (page 430). For details about settings of the [ALL] button, see "Setting the Operation Mode of the [ALL] Button in the Transition Control Block" (page 431). Note More than one next transition selection buttons can be pressed and lit at the same time. 3 To change the key overlay sequence for a transition, set the key priority for after the transition. For details about the method of operation, see "Key Priority Settings" (page 86). 4 Select the video for after the transition executes. Select the background video using the background B bus cross-point buttons. To insert a key, select the key signal, and make key settings as required. For details about key settings, see "Keys" (page 107). To carry out an instantaneous cut transition, skip to step 7. 5 Select the transition type using the transition type selection buttons. To switch gradually to the new video overlaid on the current video: Press the [MIX], [NAM], [SUPER MIX], or [PST COLOR MIX] button, turning it on. To switch from the current video to the new video using a wipe: Press the [WIPE] or [DME] button, turning it on. To play a frame memory clip while switching from the old video to the new video: Press the [FM1&2 CLIP], [FM3&4 CLIP], [FM5&6 CLIP], or [FM7&8 CLIP] button corresponding to the frame memory clip to use, turning it on. You can also use the Misc >Transition menu to select a transition type for a switcher bank (see page 89). • Wipe settings (see page 140) • DME wipe settings (see page 159) • Clip transition settings (see page 179) • Transition rate (the time from the beginning of a transition to its completion) settings (see page 91) Using transition preview mode (see page 98), you can check the transition on the preview monitor. Note When you have selected a wipe or DME wipe as the transition type, set the transition execution range (see page 93). 7 Carry out the transition in the transition execution section. To switch video gradually due to a mix or wipe, for example: Press the [AUTO TRANS] button, or operate the fader lever. When you press the [AUTO TRANS] button, the transition is executed at the set transition rate. To switch video instantaneously: Press the [CUT] button. For details, see "Executing a Transition" (page 91). Operations on the transition control block (simple type) Transition type selection buttons Note You can change the assignment of the transition selection buttons in the transition control block in the Setup menu (see page 410). 6 Make the required settings, according to the selected transition type. • Super mix settings (see page 89) • Preset color mix settings (see page 89) Transition execution section Transition control block (simple type) 85