Sony XVS-7000 Users Guide - Page 426

3 Enter a name of up to 8 characters in the keyboard window, and press [Enter]. Setting the transition rate target to display on memory recall buttons This sets the memory recall button assignments in transition rate display mode. 1 In the Engineering Setup >Panel >Prefs/Utility >Utility Module Assign menu (7324.1), press [Trans Rate Mode Assign]. The Trans Rate Mode Assign menu (7324.3) appears. 2 Select the target button to set. 3 Select the transition rate to assign. 4 Press [Set]. To release the assignment Select the target button to release, then press [Clear]. Assigning Functions to Cross-Point Buttons of the Cross-Point Control Block You can assign functions to the cross-point buttons of the cross-point control block (utility/shotbox mode). 1 In the Engineering Setup >Panel >Prefs/Utility menu (7324), press [Xpt Module Assign]. The Xpt Module Assign menu (7324.2) appears. 2 Select the target button to set. No. Parameter Adjustment 1 Bank Bank selection 2 Button No Button selection 3 In the group, select the function to assign. Menu Shortcut: Assign a frequently used menu to be recalled (menu shortcut). Utility Command: Assign a function setting (utility command). Macro Recall: Assign a macro register recall. Shotbox Recall: Assign a shotbox register recall. 4 Perform the following operations, according to the selection in step 3. When [Menu Shortcut] is selected: When a crosspoint button on the cross-point control block is blinking, display the shortcut menu. Press the target button to set to assign a shortcut. When finished, press [Menu Shortcut] again. When [Utility Command] is selected: Select a command to assign in the list on the right side of the status area. No. Parameter Adjustment 3 Command Utility command selection 4 a) GPI No GPI number a) For "DCU GPI Test Fire" only When [Macro Recall] is selected: Select a macro register to assign in the list on the right side of the status area. No. Parameter Adjustment 3 Macro Macro register selection When [Shotbox Recall] is selected: Select a shotbox register to assign in the list on the right side of the status area. No. Parameter Adjustment 3 Shotbox Shotbox register selection 5 Press [Action Set]. When [Menu Shortcut] is selected in step 3, it is not necessary to press [Action Set]. To release the assignment Select the target button to release, then press [Clear]. To display the register name in the status area list When [Macro Recall] or [Shotbox Recall] is selected, you can change the register number display to the register name. To display the register name, press [Reg Name Display], turning it on. For details about utility commands that can be assigned to cross-point buttons, see "List of utility commands and user preference button states" (page 421). Settings names to show on the display You can set the names to display when menu shortcuts or utility commands are assigned to cross-point buttons. Note When a macro register is assigned, the names specified in the Macro menu are displayed on the display. When a shotbox register is assigned, the names specified in the Shotbox menu are displayed on the display. 426