Sony XVS-7000 Users Guide - Page 442
Setting the Sub Key Mode, Setting the Keys and DME Channels, used in a CG Border
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 442 highlights
To set to crop to 4:3 when a DME wipe is executed When side flags are enabled, you can automatically crop an image to be a 4:3 image when executing a DME wipe. In the Side Flags menu (7331.7), press [Auto Crop], turning it on. The settings are common to the M/E and PGM/PST banks. Adjusting the width of the side flags 1 In the Engineering Setup >Switcher >Config >Side Flags menu (7331.7), press [Width]. 2 Set the following parameters. No. Parameter Adjustment 3 Left Width of left side flag 4 Right Width of right side flag 5 All Width of left and right side flags Enabling and disabling side flags Press a button in the Engineering Setup >Switcher >Config >Side Flags menu (7331.7) to display the setup menu. To enable/disable side flags in the menu Press [Misc >Enable >Side Flags] to open the Misc >Enable >Side Flags menu (3213) and configure the settings (see page 196). To assign side flag operation buttons to crosspoint buttons Press [Side Flags Button Assign] to open the Engineering Setup >Panel >Xpt Assign >Side Flags Button Assign menu (7322.10) and configure the settings (see page 416). Setting the Sub Key Mode You can set the sub key mode used for 3840×2160P format. If only key 3 is set, the key preview function is enabled using the sub key. 1 In the Engineering Setup >Switcher >Config menu (7331), press [Key Config]. The Key Config menu (7331.9) appears. 2 In the status area, select the target switcher bank to set. 3 In the group, select the sub key mode. Key3, Key4: Use key 3 and key 4 as sub keys (key preview is disabled). Key3 + Key PVW: Use only key 3 as a sub key (key preview is enabled). Setting the Keys and DME Channels used in a CG Border You can set the keys and DME channels used when changing the position and size of the image embedded in the CG border. 1 In the Engineering Setup >Switcher >Config menu (7331), press [CG Border Int Video Ch Assign]. The CG Border Int Video Channel Assign menu (7331.15) appears. 2 In the status area, select the target switcher bank to set. 3 In the to groups, select the DME channels. Ch1-2: Set DME channels 1 and 2 for the CG border with the target key (Key1 to Key8). Ch3-4: Set DME channels 3 and 4 for the CG border with the target key (Key1 to Key8). Note [Ch1-2] cannot be selected if DME channel 1 or 2 is assigned to the target key. Similarly, [Ch3-4] cannot be selected if DME channel 3 or 4 is assigned to the target key. Setting Extended Re-Entry When extended re-entry is enabled, the restrictions relating to re-entry signal selection are removed. The following two types of extended re-entry can be configured. • Extended re-entry for switcher banks Re-entry signals can be selected within the same switcher bank. • Extended re-entry for keyers Re-entry signals can be selected using key bus/utility 1 bus (regardless of constraints, such as M/E configuration) when the switcher signal format is 3840×2160P or 1080P. Notes • The extended re-entry settings are common to all switcher banks. • Extended re-entry for keyers is available only when the switcher signal format is 3840×2160P or 1080P. • A delay may occur in the re-entry signal when extended re-entry is enabled. If a delay occurs, the ancillary data is disabled, even when through mode is set. • Recursive re-entry may cause problems in the video. 442