Sony XVS-7000 Users Guide - Page 388

The NFS server address is displayed in the "NFS Server Address" field. 3 To register the setting as a power-on default, press [Define]. 4 Check the message, then press [Yes]. Mounting the NFS server In the Engineering Setup >System >Network Config menu (7311), press [NFS Mount], turning it on. The configured NFS server is mounted, ready for use. Note Resetting the menu panel will unmount the NFS server. To use an NFS server after resetting the menu panel, mount the server again. Initializing Network Interface Settings You can initialize the network interface settings for a network connector board. For details about network interface settings, see "Configuring a Network Interface" (page 388). 1 In the Engineering Setup >System >Network Config menu (7311), press [Net I/F Initialize]. The Net I/F Initialize menu (7311.1) appears. 2 In the group, select the target switcher to set. 3 In the status area, select the target slot to set. To select all slots, press [ALL]. 4 Press [Factory Reset]. To reset a connector board only Press [Reset]. 5 Press [Execute]. 6 Check the message, then press [Yes]. Setting the Network Connector Board Service Port The service port can be enabled/disabled when an XKS-C8111/XKS-C9111/XKS-C9111N/XKS-C9121/ XKS-C9121N/XKS-C8166 is installed. The service port is used for board maintenance. Note The unit is equipped with a function to perform board maintenance via a network. If maintenance is required, this function is used with the consent of the customer. For details, consult your Sony service or sales representative. 1 In the Engineering Setup >System >Network Config menu (7311), press [Net I/F Initialize]. The Net I/F Initialize menu (7311.1) appears. 2 In the group, select the target switcher to set. 3 In the status area, select the target slot to set. To select all slots, press [ALL]. 4 Enable or disable the service port. To enable, press [Service Port], turning it on. To disable, press [Service Port], turning it off. 5 Press [Execute]. 6 Check the message, then press [Yes]. The connector board in the selected slot is reset, and the service port setting is applied. Note If the network interface is initialized (see page 388) and the service port setting is applied simultaneously to the same slot, the initialization operation takes precedence, and the service port setting is not changed. Configuring a Network Interface You can configure the interface for a network connector board. The network interface settings are for the slots in which the following network connector boards are installed. XVS-9000: • XKS-C9111 • XKS-C9111N • XKS-C9121 • XKS-C9121N XVS-8000/7000/6000: • XKS-T8110 • XKS-Q8111 • XKS-C8111 • XKS-T8165 • XKS-Q8166 • XKS-C8166 388