Sony XVS-7000 Users Guide - Page 179
Clip Transitions, Clip Transition Settings
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 179 highlights
Clip Transitions You can play a frame memory clip linked to a background transition, such as a mix or wipe. Only eight channels comprising FM1 to FM8 (FM1&2 Clip, FM3&4 Clip, FM5&6 Clip, FM7&8 Clip) can be used in a clip transition. Clip transition restrictions • Pattern limits cannot be used. • Transition preview cannot be used. • It is not possible to set the transition rate of a clip transition. • Keyframe capture is not possible. • The state of a clip transition during execution cannot be saved as a snapshot. • When recalling a snapshot that includes a clip transition while executing another clip transition, the subsequent transition does not operate properly. Recall the snapshot after the transition completes. • Transitions executed in two strokes, such as a preset color mix with the stroke mode set to [Normal], or a DME wipe with a picture-in-picture pattern, will not execute correctly. Notes • In 4K format, only four channels comprising FM1 to FM4 (FM1&2 Clip, FM3&4 Clip) can be used. • When a clip transition is selected as the transition type, the wipe direction selection button in the transition control block that is lit indicates the direction of clip playback. The Frame Memory >Clip/Still >Recall menu (2111) appears. 4 Select a clip file in memory, and recall the file on the FM1 and FM2 output. For details about the method of operation, see "Recalling Clips" (page 177). 5 Return to the Clip Transition menu (1176), and select the background transition type in the group. Note In the M/E-1 >Misc >Transition menu (1171) or other menus, configure a background transition, as required. 6 In the group, press [BKGD Transition]. 7 Using one of the following methods, set the start point of the background transition. • Move the fader lever to the start point, and press [Start] in the group. • Set the number of frames using the [BKGD Trans Start] parameter (left edge of the reference axis is frame 0). Position of frame 0 Reference axis Clip Transition Settings This section describes clip transitions using FM1&2 Clip on the M/E-1 bank as an example. Note To use a clip transition effectively, the image from the frame memory clip image that is played back during the clip transition must be reflected in the M/E-1 program image beforehand. For example, the settings for inserting a key using FM1 and FM2. 1 In the group of the M/E-1 >Misc >Transition menu (1171), select [FM1&2 Clip]. 2 Press [Clip Transition]. The Clip Transition menu (1176) appears. 3 Press [Clip >Recall]. 8 Using one of the following methods, set the end point of the background transition. • Move the fader lever to the end point, and press [Stop] in the group. • Set the number of frames using the [BKGD Trans Stop] parameter. 9 If [Wipe] or [DME Wipe] is selected in the group, select the wipe direction in the group. 10 In the group, press [FM1&2 Clip]. 11 Using one of the following methods, set the start point of the clip. • Move the fader lever to the start point, and press [Start] in the group. 179