Sony XVS-7000 Users Guide - Page 35

a Mode selection buttons These buttons select the operation mode of the Flexi Pad control block. Press a mode selection button to change the memory recall section to the display for the selected operation mode. You can change the assignment of mode selection buttons in the Setup menu. For details, see "Setting Flexi Pad Control Block Button Assignments" (page 410). Button name Description KEY Switches to key operation mode. In key operation mode, you can carry out the following operations. • Saving and recalling key snapshots • Selecting independent key transition type • Displays/selects the key source signal in the cross-point control block WIPE (wipe snapshot) Switches to wipe snapshot operation mode. In wipe snapshot operation mode, you can save and recall wipe snapshots, and select the wipe pattern. DME WIPE (DME wipe snapshot) Switches to DME wipe snapshot operation mode. In DME wipe snapshot operation mode, you can save and recall DME wipe snapshots, and select the DME wipe pattern. SNAPSHOT Switches to snapshot operation mode. In snapshot operation mode, you can save and recall snapshots, and add attributes. MASTR EFF (master effect) Switches to effect operation mode. In effect operation mode, you can recall and execute the master timeline. SHOTBOX Switches to shotbox operation mode. In shotbox operation mode, you can recall and execute shotboxes. MCRO (macro) Switches to macro operation mode. In macro operation mode, press and hold the [MCRO] button and press a button (for the target register) in the memory recall section to enter edit mode. In macro operation mode, you can save, recall, and edit macros. TRANS RATE (transition rate) Switches to transition rate operation mode. In transition rate operation mode, you can enter the transition rate. b Memory recall section This section displays the functions assigned to the buttons for the selected operation mode. The top right button is used to display the selected pattern number, register number, macro event number, transition rate input value, and other status display (excluding in key operation mode). When a macro is recalled in macro operation mode, the bottom center button displays the executed event number and the total number of events. Numeric keypad mode Pressing the [BANK SEL] button, [PTN NO.] button, or [PAUSE] switches the memory recall section to numeric keypad mode, where you can enter bank numbers, wipe pattern numbers, and pause event times. The currently set numeric value or the value entered using in numeric keypad mode is displayed on the top right button. c UNDO button/DEL (delete) button After recalling a register, press the [UNDO] button to return to the state before the register was recalled. Or press and hold the [DEL] button and press a register button in the memory recall section to delete the data registered in the button. You can change the assignment of buttons in the Setup menu. For details, see "Setting Flexi Pad Control Block Button Assignments" (page 410). Note The [UNDO] button and [DEL] button cannot be used in effect operation mode or shotbox operation mode. The [UNDO] button cannot be used in macro operation mode. d Bank selection buttons These select the target bank to control, and switches the memory recall section to the register display for the selected bank. You can change the assignment of bank selection buttons in the Setup menu. For details, see "Key Snapshot Operations (Flexi Pad Control Block)" (page 138). Button name BANK0 to BANK25 Description (Assignment of [BANK3] to [BANK25] is required.) Switches the memory recall section to the register display for the selected bank. 35