Sony XVS-7000 Users Guide - Page 177

7 Press [Record Stop] at the position you want to stop recording. The clip file is saved in memory. To enable V/K mode Press [V/K Mode], turning it on. For details, see "V/K mode" (page 170). To create a clip by specifying the duration Press [Clip Duration], and enter a timecode value or number of frames using the numeric keypad window. The specified duration is displayed in the status area in the center of the screen. Pressing [Record Start] starts recording, and then recording stops when the specified duration elapses. If "0" is specified for the duration, recording continues until the free capacity in memory has been consumed. To play audio data during recording Press [Audio], turning it on. For details about audio data, see "Frame memory audio data" (page 170). To save clip files in storage Select a file stored in memory in the folder/file selection area. A confirmation message appears. Select [Yes] to start saving the file in storage. Playing a Clip You can play a clip recalled on an FM output from the menu or by using the device control block (trackball). Note With a pair file recalled, it is possible to disable pair mode and carry out single file operations, but if you then reenable pair mode, the output of frame memory may become black. If this occurs, recall the pair file again. Playing a clip (menu) 1 In the Frame Memory >Clip/Still >Recall menu (2111), recall the file to play on the target FM output. 2 Open the Frame Memory >Clip/Still >Play menu (2112). The following information is displayed in the status area in the center of the screen. Start of clip Duration End of clip Note A file within a locked folder cannot be saved in storage. Recalling Clips Selecting a clip file in memory recalls the file on an FM output. 1 Open the Frame Memory >Clip/Still >Recall menu (2111). 2 Select the target FM output for operation in the FM output selection area. For details about the method of operation, see "Selecting an FM Output" (page 173). 3 Select the file to recall in the folder/file selection area. You can also enter the name of a folder/file to search for (see page 174). A light-blue frame is applied to the selected file, and the image is recalled on the target FM output. Playback stop point (yellow bar) Current position (red bar) Playback start point (light-blue bar) Icon display Start point, current position, and stop point thumbnails and timecodes Note If a playback operation is performed immediately after a clip is created, the icon display thumbnail may not be displayed (black display). Some time may be required, depending on the clip file, before the thumbnail is displayed. 3 Press [Play]. Playback starts. To stop playback, press [Stop]. To repeat playback (looping) In the group, select one of the following. Loop: When the playback stop point is reached, playback continues from the playback start point, and then repeats. 177