Sony XVS-7000 Users Guide - Page 408
Linking Transitions Between Keyers, Setting the Buttons and Fader, Levers on the Key Fader Control
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 408 highlights
No. Parameter Adjustment 2 Source No Matrix source 3 Press [Link Source Set]. 4 Repeat steps 2 and 3 as required to select the matrix sources to be linked to other cross-point buttons. To return the set combinations to the defaults Press [Init Link Table], check the message, then press [Yes]. Setting the link bus Make settings for the link number selected in the External Bus Link menu (7321.3). 1 In the Engineering Setup >Panel >Config >Link/ Program Button >External Bus Link menu (7321.3), press [Link Bus Adjust]. The Link Bus Adjust menu (7321.6) appears. You can also select the link number in this menu using the [Link No] parameter. 2 Select the switcher bus and the link target router destination. No. Parameter Adjustment 2 Internal Switcher bus Bus 3 Destination Router destination 3 Perform the following operations. • To apply the bus, press [Master Bus Set]. • To apply the destination address, press [Linked Dest Set]. Linking the next transition selection buttons You can add links for the next transition selection buttons in the transition control block to the transition link settings between keyers. For example, if two keyers (Key 2 and Key 3) are linked with the master keyer (Key 1), then pressing the [KEY1] next transition selection button also selects the [KEY2] and [KEY3] buttons. 1 In the Engineering Setup >Panel >Config >Link/ Program Button >Key Trans Link menu (7321.2), set the transition link between keyers (see page 408). 2 Press [Next Trans Link], turning it on. The [KEY1] to [KEY8] next transition selection buttons in the transition control block are coupled (selected) to the transition link setting between the keyers. Note The link setting of the next transition selection buttons is common to the keyers on all switcher banks. It is not possible to make separate settings for each master keyer. Setting the Buttons and Fader Levers on the Key Fader Control Block You can assign keys (KEY1 to KEY8) of any switcher bank (M/E-1 to M/E-5, PGM/PST) to the key delegation buttons on the key fader control block. You can also set the key delegation button for operation by the fader lever. Linking Transitions Between Keyers 1 In the Engineering Setup >Panel >Config menu (7321), press [Link/Program Button]. The Link/Program Button menu (7321.8) appears. 2 In the group, press [Key Trans Link]. The Key Trans Link menu (7321.2) appears. 3 Select the keyer to be the master. No. Parameter Adjustment 1 Master Key Master keyer 4 In the group, select the keyer to link to the transition of the master. Setting key delegation button assignments 1 In the Engineering Setup >Panel >Config menu (7321), press [Key Fader Assign]. The Key Fader Assign menu (7321.1) appears. The status area shows the settings of the key delegation buttons 1 to 4 and the fader levers for each module in the key fader control block. 2 Select the target key delegation button to assign in the status area. 3 In the group, select the bank with the key to assign. 4 In the group, select the key to assign. 408