Sony XVS-7000 Users Guide - Page 94
Executing an Auto Transition, Setting the pattern limit menu, Executing a pattern limit transition
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
2 Press the [LIMIT SET] button. This sets the current fader lever position as the pattern limit. Setting the pattern limit (menu) This section describes setting the pattern limit on the M/E-1 bank as an example. 1 Display the pattern limit setting menu. When the transition type is a wipe, open the M/E-1 >Wipe >Edge/Direction menu (1154). When the transition type is a DME wipe, open the M/E-1 >DME Wipe >Edge/Direction menu (1164). 2 Press [Pattern Limit], turning it on. 3 Set the following parameter. No. Parameter Adjustment 1 Pattern Pattern limit range a) Limit a) 0.00%: Executing the transition does not change the video output. 100.00%: The transition is the same as when the pattern limit is disabled, but the cross-point button selections of the background A and B buses do not interchange when the transition completes. Executing a pattern limit transition 1 Press the [PTN LIMIT] button. The [PTN LIMIT] button is lit amber. 2 Execute the transition. The transition progresses as far as the set pattern limit. Even if the transition completes, the cross-point button assignments of the background A and B buses do not interchange. 3 Execute the transition once again. The status before the previous transition is restored. To cancel the pattern limit If the pattern limit is restored to the previous value by executing step 3, press the [PTN LIMIT] button, turning it off. If the pattern limit is applied by executing step 2, carry out the following procedure. 1 Press the [PTN LIMIT] button. The [PTN LIMIT] button is lit green. 2 Execute the transition. When the transition is completed, the [PTN LIMIT] button turns off, and the pattern limit is released. Depending on the transition execution method, the action will be as follows. • When you press the [CUT] button, the pattern limit is immediately released, and the video switches instantaneously. • When you press the [AUTO TRANS] button (or [TAKE] button), until the next transition state, the transition is executed over the duration given by the transition rate. • When you move the fader lever, the transition is executed from the pattern limit state to the state before the pattern limit was executed. Moving the fader lever even a little synchronizes the fader lever position with the transition state, and you can move the fader lever either in the forward direction or in the reverse direction. Depending on the Setup menu settings, the transition is executed at the instant you press the [PTN LIMIT] button, turning the button off. In this case, execution continues for the time specified by the independent transition rate in the menu, up to the next transition state. To set the transition rate when the pattern limit is released This section describes setting the transition rate on the M/E-1 bank as an example. 1 In the group in the M/E-1 >Wipe >Edge/Direction menu (1154) or M/E-1 >DME Wipe >Edge/Direction menu (1164), select one of the following. Auto Trans Rate: Transition rate set in the transition control block Independ Trans Rate: Independent transition rate 2 If [Independ Trans Rate] is selected, adjust the following parameter. No. Parameter Adjustment 1 Transition Independent transition rate Rate Executing an Auto Transition The following two modes can be used for auto transition. Cut A cut switches instantaneously from the current video to the new video. When the next transition is a key, the key is inserted (cut in) or removed (cut out) instantaneously. 94