Sony XVS-7000 Users Guide - Page 287

Button REC (record) a) START TC (start timecode) STOP TC (stop timecode) STB OFF (standby off) a) STOP CUE REW (rewind) PLAY FF (fast forward) ALL STOP FINE a) VAR (variable playback) SHTL (shuttle) JOG Operation Press the [REC] button at the same time as the [PLAY] button to start recording. Update the timecode of the start point to the current time. Update the timecode of the stop point to the current time. Switch to standby off mode. Stop operation. Cue up to the start point. Rewind. Play. Fast forward. Stop all tapes, disks, and frame memory clips. (Only available when video disk communications protocol is used) Enable fine adjustment through Z-ring operation while the [SHTL] button or [JOG] button is pressed (fine mode). Enable playback or rewind at variable speed. Enable playback or rewind in shuttle mode. Enable playback or rewind in jog mode. a) This button cannot be used for frame memory clip operations. Selecting the target device Press the channel selection buttons (CH1 to CH12) on the device control block to make the selection. You can select more than one channel. The first selected button becomes the reference channel, and is lit green. Subsequent selected buttons are lit amber. For details about frame memory clip operations, see "Clip Operations" (page 176). Controlling the tape/disk transport You can use the operation buttons in the device control block to control the tape transport or the disk transport. You can also assign play, stop, and cuing to buttons in the transition control block using the Setup menu to perform these operations. For details, see "Setting Transition Control Block Button Assignments" (page 410). Variable speed playback With the device control block, you can play back the material on an external device in variable speed. If you turn the Z-ring during video playback, the direction and speed of playback are determined by the direction and angle of rotation. Perform operation in one of three modes; jog, shuttle, or variable. Jog mode Press the [JOG] button, lighting the button amber, to switch the Z-ring to jog mode. In this mode, you can advance material frame by frame at a speed proportional to the rotation speed of the Z-ring. To show a still image, stop turning the Z-ring. Reverse direction Forward direction Shuttle mode Press the [SHTL] button, lighting the button amber, to switch the Z-ring to shuttle mode. In this mode, the playback speed varies in steps according to the rotation angle of the Z-ring, to a maximum of 50 times normal. Low speed Still image Low speed Reverse direction Forward direction Maximum speed Maximum speed Variable mode Press the [VAR] button, lighting the button amber, to switch the Z-ring to variable mode. In this mode, the playback speed varies according to the rotation angle of the Z-ring from -1 to +3 times normal speed. Low Still image speed Low speed Reverse direction Forward direction -1x +1x +3x To disable the Z-ring and end a variable speed playback mode, press the [STOP] button. Additionally, pressing any of the [REW], [PLAY], [FF], [STB OFF], and [ALL 287