Sony XVS-7000 Users Guide - Page 92

Setting the transition rate (Flexi Pad control block) TRANS RATE button TC button CLEAR button displaying a transition rate enables you to enter a transition rate using the numeric keypad control block. You can change the target that is displayed on the [TRANS RATE1] to [TRANS RATE3] buttons in the Setup menu (see page 426). Display CLR button ENTER button Memory recall section Flexi Pad control block 1 In the Flexi Pad control block of the target switcher bank, press the [TRANS RATE] button. This switches the memory recall section to transition rate operation mode. 2 Enter the transition rate in the numeric keypad. You can switch the input mode using the [TC] button. In frame input mode, enter three digits. In timecode input mode, enter four digits. The entered value appears in the top right of the memory recall section. To clear the entered value, press the [CLEAR] button. 3 Press the [ENTER] button. Setting the transition rate (utility/shotbox control block and numeric keypad control block) Pressing the [TRANS RATE1] to [TRANS RATE3] buttons on the utility/shotbox control block displays the transition rates set in the switcher bank or key on the memory recall buttons. Pressing a memory recall button ENTER button Numeric keypad buttons TC button Numeric keypad control block 1 Press the [TRANS RATE1] to [TRANS RATE3] buttons in the utility/shotbox control block. This switches the memory recall buttons to transition rate display mode. 2 Press a memory recall button displaying the transition rate to set, turning it on. The region name and transition rate appears in the numeric keypad control block display. 3 Enter the transition rate using the numeric keypad in the numeric keypad control block. You can switch the input mode using the [TC] button. In frame input mode, enter three digits. In timecode input mode, enter four digits. To clear the entered value, press the [CLR] button. 4 Press the [ENTER] button. The input is applied, and the specified value is reflected in the memory recall button in the utility/ shotbox control block. The specified value is also displayed in the transition rate display section of the transition control block. 92