Sony XVS-7000 Users Guide - Page 534

System Interface Unit Board MKS-X2700/X7700 CA-90 STATION ID switches S3801 When finished, reboot the SIU (power off and then on again). 4 In the Engineering Setup >Router/Tally >Router menu (7361), set the position in the XVS-9000/8000/7000/ 6000 system S-Bus space. Select the setting from SWR1 and SWR2, and set each of Source, Destination, and Level to 1. Z: SET PANEL STATUS The various settings are the same as the factory default settings. Setting Status of the MKS-8080/8082 in Simple Connection As a result of making the simple connection, the MKS-8080/8082 operates in AUX bus mode, and the settings are the following factory defaults. With regard to the meaning of the following settings, refer to the "Menu Operations" section in the Operation Manual for the MKS-8080/8082. C: SET SWITCHER ID (for AUX mode) This is set to 001, which is the station number of the SIU. D: SET AUX DESTINATION/SOURCE (for AUX mode) The source is set to IN001 and following, and destination is set to OUT001 and following. H: SET PHANTOM TABLE (for Router mode) This is not set, since the unit does not operate in router mode. N: SET PANEL TABLE (for Router mode) The source is set to IN001 and following, and destination is set to OUT001 and following. However, since the unit does not operate in router mode, these settings are not used. O: SET AVAILABLE SOURCE/DESTINATION Set the source and destination ranges so that the XVS-9000/8000/7000/6000 inputs and outputs can be selected. R: SET ROUTE Since when using the simple connection the switcher and router cannot be connected in cascade, no route setting is required, and this is not set. Y: SET DISPLAY MODES The DISPLAY MODES/PANEL FUNCTION setting is set to NORMAL. The TALLY GROUP settings match the settings in the Engineering Setup >Router/Tally >Group Tally menu (7362). 534