Sony XVS-7000 Users Guide - Page 338

Utility Execution (Utility/Shotbox Control Block) Mode selection buttons • For actions that enable/disable a function, the selected button is lit orange, and the function is enabled. To disable the function, press the button again. • For other actions, the function for the selected button is executed. Utility Execution (Cross-Point Control Block) 1st row Memory recall buttons Utility/shotbox control block In the utility/shotbox control block, you can assign actions to 24 memory recall buttons on each of banks 1 to 20. The bank is switched using the mode selection buttons. The [BANK1] to [BANK6] bank 1 to 6 mode selection buttons are assigned by default. Action and button assignments are made in the Setup menu. For details about action assignment, see "Assigning a Function to a Memory Recall Button in the Utility/Shotbox Control Block" (page 423). For details about mode selection button assignment, see "Setting Utility/Shotbox Control Block Button Assignments" (page 411). To execute an assigned action 1 Select the target bank using the mode selection buttons. The selected button is lit amber, and the control block switches to function recall mode. The functions for the selected bank are assigned to the memory recall buttons, and the function numbers "n-1" to "n-24" (where n is the bank number) are displayed. The function name is displayed if a name has been specified for the function in the Setup menu. 2 Press the memory recall button with the registered action you want to execute. Cross-point pad Cross-point control block You can assign actions to the cross-point buttons on the cross-point control block, and then select them in utility/ shotbox mode. You can set assignments for each button on utility/shotbox banks 1 to 10. The settings are common to the M/E and PGM/PST banks. To switch to utility/shotbox mode, use the bank 1 to 10 delegation buttons [UTL/SB 1] to [UTL/SB10] in the cross-point pad. Action and button assignments are made in the Setup menu. For details about action assignment, see "Assigning Functions to Cross-Point Buttons of the Cross-Point Control Block" (page 426). For details about delegation button assignment, see "Assigning a function to a cross-point pad button" (page 433). Note You can assign the bank 1 to 10 delegation buttons for utility/shotbox operation to the 1st row of the cross-point control block in key/AUX bus delegation mode in the Setup menu (see page 432). 338