Sony XVS-7000 Users Guide - Page 469
Settings Relating to Function Links, Setting a Cross-Point Button Link
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 469 highlights
Note This setting is enabled for the attributes of snapshots as well as the operation mode of the cross-point hold button. Setting the operation mode when the pattern limit is released In the group of the Engineering Setup >Switcher >Key/Wipe/FM menu (7335), select one of the following. Auto: When the pattern limit is released, the remainder of the transition is executed automatically at a dedicated transition rate. Manual: After the pattern limit is released, the transition waits for the next operation, then executes. The transition is not executed until you move the fader lever or press the [AUTO TRANS] button (or [TAKE] button). Setting the default wipe edge softness 1 In the Engineering Setup >Switcher >Key/Wipe/FM menu (7335), press [Wipe Edge Default], turning it on. 2 Set the following parameter. No. Parameter Adjustment 3 Soft Default value of wipe edge softness Settings Relating to Function Links Setting a Cross-Point Button Link This configures the bus link function that links together two buses within the switcher. Setting a bus link 1 In the Engineering Setup >Switcher >Link menu (7336), press [Internal Bus Link]. The Internal Bus Link menu (7336.1) appears. 2 Select the target link number to set. 3 Press [Link Bus Select]. The Link Bus Select menu (7336.2) appears. The bottom of the status area shows a list of selectable buses. 4 In the group, select [Master Bus] (link source). 5 Select the bus for the link source, and press [Bus Set]. M/E-1 to 5 Trans PGM and P/P Trans PGM can be set only when [Master Bus] is selected. Note When one of M/E-1 to M/E-5 Trans PGM or P/P Trans PGM is selected for [Master Bus], the link setting becomes effective as soon as you start moving the fader lever. 6 In the group, select [Linked Bus] (link destination). 7 Select the bus for the link destination, and press [Bus Set]. AUX1 to 48 as Key can be set only when [Linked Bus] is selected. 8 Select the link table number, and press [Link Table Set]. No. Parameter Adjustment 3 Link Table Link table number No 469