Sony XVS-7000 Users Guide - Page 39
Key Fader Control Block, Key delegation buttons, Display, Key snapshot operation buttons
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Key Fader Control Block The key fader control block is used to execute independent key transitions and for key snapshot operations. a Key delegation buttons b Display c Key snapshot operation buttons d Independent key transition type selection buttons e Independent key transition execution section a Key delegation buttons These buttons select the target key to operate. The four buttons are key delegation buttons 1 to 4 in the order top left, top right, bottom left, and bottom right. You can assign a key (KEY1 to KEY8) of any switcher bank (M/E-1 to M/E-5, PGM/PST) in the Setup menu. For details, see "Setting the Buttons and Fader Levers on the Key Fader Control Block" (page 408). b Display The following information is displayed for the four keys assigned to the key delegation buttons. • Key material name (key source name when a key source is selected on the key bus of the cross-point control block) • DME channel or resizer being used • Transition rate • Transition type • In key snapshot operation mode, the register name of the key selected using the key delegation button c Key snapshot operation buttons Recalls and saves key snapshots. Button name Description K-SS 1 to K-SS 4 (key Selects key snapshot register 1 to snapshot 1 to key 4. snapshot 4) Button name K-SS (key snapshot) K-SS STORE (key snapshot store) UNDO Description • Switches to key snapshot operation mode. • Recalls and saves a key snapshot. Pressing and holding the [K-SS STORE] button and pressing the [K-SS 1] to [K-SS 4] buttons saves the key snapshot in the selected register. After recalling a key snapshot, returns to the state before the key snapshot was recalled. d Independent key transition type selection buttons These select the independent key transition type. • MIX button • WIPE button • DME WIPE button • CUT button When [Independ] is selected in the group of the Engineering Setup >Switcher >Transition menu (7334), you can set the transition type used when inserting and removing a key. If the transition type used when inserting a key is displayed, you can select the transition type used when removing a key by pressing and holding the [SHIFT] button and pressing an independent key transition type selection button. If the transition type used when removing a key is displayed, you can select the transition type used when inserting a key using the same operation. 39