Sony XVS-7000 Users Guide - Page 528
Click/tap [Select] in [Logical Switcher Setting] for a, 3840×2160P SQD or 3840×2160PsF SQD, DMEs
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 528 highlights
The status of the current resource assignments are displayed in [Resource Configuration] (total number of resources, number assigned to logical switcher 1, number assigned to logical switcher 2). Click/tap [Select] in [Logical Switcher Setting] for a resource to display the resource configuration pop-up window. To assign the resource to logical switcher 1, select [1]. To assign the resource to logical switcher 2, select [2]. When finished, click/tap [Done] to close the pop-up window. Notes • On the XVS-9000, internal format converters are not available. • Multi viewer output assignment is supported only on the XVS-9000. • The following resources can be configured for sharing on logical switchers 1 and 2. - Inputs - Frame memory outputs (only when the signal formats of logical switchers 1 and 2 are the same) - Color backgrounds (only when the signal formats of logical switchers 1 and 2 are the same) - Internal format converters (only when the signal formats of logical switchers 1 and 2 are the same) • If a logical switcher is set to 4K format, the number of the following resources that are available for 4K format use is shown in parentheses. On the XVS-9000, the numbers in parentheses are displayed in "12G:xx/3G:xx" format (xx represents the number of resources), so you can check the number of inputs/outputs available for 12G-SDI and 3G-SDI. - Inputs - Outputs - Frame memory outputs - Color backgrounds - Multi viewer outputs - Internal format converters Input settings Click/tap [Select] for [Input (ch)] to display the pop-up window. Select [1] or [2] for each group. Select both [1] and [2] to share on logical switchers 1 and 2. Output settings Click/tap [Select] for [Output (ch)] to display the popup window. Select [1] or [2] for each group. Switcher bank (M/E) settings Click/tap [Select] for [Mix (board)] to display the popup window. Select [1] or [2] for each board. DME settings Click/tap [Select] for [DME (board)] to display the pop-up window. Select [1] or [2] for each board. Notes • When the logical switcher signal format is 3840×2160P SQD or 3840×2160PsF SQD, DMEs cannot be used. • DME functionality on up to four channels can be used on a single logical switcher. Frame memory source settings Click/tap [Select] for [FM Source (ch)] to display the pop-up window. Select [1] or [2] for the two systems. 528