Sony XVS-7000 Users Guide - Page 487
Tally Generation Settings, Deleting Wiring Settings, Configuring Tally Generation
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 487 highlights
No. Parameter Adjustment 1 Destination Destination address (Address) 2 Destination Destination level (Level) 3 Source Source address (Address) 4 Source Source level (Level) 3 Press [Execute]. Deleting Wiring Settings 1 In the Engineering Setup >Router/Tally >Wiring menu (7363), select the wiring. 2 Press [Delete]. Sorting Wiring Settings In the Engineering Setup >Router/Tally >Wiring menu (7363), press [Sort]. The sorting of wiring settings is executed in the following sequence. Destination level order (ascending) t Destination address order (ascending) t Source level order (ascending) Tally Generation Settings Specify the destination to be the reference for tally generation, and configure the settings. The settings used are common to both parallel and serial tallies. Configuring Tally Generation 1 In the Engineering Setup >Router/Tally >Tally Enable menu (7364), press [New]. The New menu (7364.1) appears. 2 Set the following parameters. No. Parameter Adjustment 1 Destination Destination address Address 2 Destination Destination level Level 3 Tally Type Tally type a) a) 1: R1, 2: G1, 3: R2, 4: G2, 5: R3, 6: G3, 7: R4, 8: G4, 9: R5, 10: G5, 11: R6, 12: G6, 13: R7, 14: G7, 15: R8, 16: G8 (R stands for Red Tally, and G for Green Tally) 3 In the group, specify the tally generation mode. Enable: Always generate a tally. Disable: Never generate a tally. Tally Input: Generate a tally from the tally input state. 4 When [Tally Input] is selected in step 3, select one of the following in the group. DCU1: Generate tally with reference to signal that is input on the SIU1 (DCU function) port. DCU2: Generate tally with reference to signal that is input on the SIU2 (DCU function) port. Select the tally input port number using the following parameter. No. Parameter Adjustment 5 Input Port Tally input port number 5 Press [Execute]. Modifying Tally Generation 1 In the Engineering Setup >Router/Tally >Tally Enable menu (7364), press [Modify]. 487