Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 151

AG-1024 5 AG-1024 Message F_Port is failed back to its preferred N_Port . Message Type LOG Severity INFO Probable Cause Indicates that the specified N_Port is failing back F_Ports, which are failed over to some other N_Port. Recommended Action Execute the ag --mapshow command to display the updated F_Port-to-N_Port mapping. AG-1025 Message Port group of Slave N_Port is different than its Master N_Port . Message Type LOG Severity ERROR Probable Cause Indicates that the port groups of the Master and Slave N_Ports are different, while the trunk area assigned to the attached F_Ports on the edge switch is the same. Recommended Action Execute the porttrunkarea --show command on the attached switch to verify that the trunk area is assigned to all ports in the system, and execute the porttrunkarea --enable command to reconfigure the trunk area. AG-1026 Message Unable to handle the login request on port due to insufficient resources. Message Type LOG Severity WARNING Probable Cause Indicates that there are insufficient resources to accept the login request. Recommended Action Execute the configure command on the Access Gateway switch and increase the number of allowed logins on the specified port. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. Fabric OS Message Reference 129 53-1002749-01