Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 186

5 BL-1003 BL-1003 Message Faulting blade in slot . Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates a faulty blade in the specified slot. Recommended Action Make sure that the blade is seated correctly. If the blade is seated correctly, execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the message persists, replace the blade. BL-1004 Message Suppressing blade fault in slot . Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that the specified blade experienced a failure but was not faulted due to a user setting. Recommended Action Execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the message persists, replace the blade. BL-1006 Message Blade NOT faulted. Peer blade experienced abrupt failure. Message Type LOG Severity INFO Probable Cause Indicates that the errors (mostly synchronization errors) on the specified blade are harmless. Probably, the standby control processor (CP) blade connected to the active CP blade has experienced transitory problems. Recommended Action Execute the haShow command to verify that the standby CP is healthy. If the problem persists, remove and reinstall the faulty blade. If the standby CP was removed or faulted by user intervention, no action is required. 164 Fabric OS Message Reference 53-1002749-01