Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 316

5 EM-1067 EM-1067 Message Stopping synchronization of the system due to incompatibility with standby CP. Message Type LOG Severity WARNING Probable Cause Indicates that the software version on the standby control processor (CP) is incompatible with this software feature enabled on this Fabric OS firmware version. Recommended Action Upgrade the software on the standby CP or disable the software feature on this CP. To disable the Ethernet switch service, execute the fosconfig --disable ethsw command. To view the buffer optimization mode for the slots, execute the bufopmod --showall command, and then execute the bufopmode --reset slot command to disable the feature for those slots before downgrading. To disable FC8-16 Serdes tuning mode, execute the serdestunemode --reset command. EM-1068 Message High Availability Service Management subsystem failed to respond. A required component is not operating. Message Type FFDC | LOG Severity ERROR Probable Cause Indicates that the high availability (HA) subsystem has not returned a response within four minutes of the request from the environmental monitor (EM). It usually indicates that some component has not started properly or has terminated. The specific component that has failed may be indicated in other messages or debug data. There are serious internal Fabric OS configuration or hardware problems on the switch. Recommended Action Restart or power cycle the switch. If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. EM-1069 Message Slot is being powered off. Message Type LOG Severity INFO Probable Cause Indicates that the blade in the specified slot is being intentionally powered off. Recommended Action No action is required. 294 Fabric OS Message Reference 53-1002749-01