Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 344

5 FABS-1005 FABS-1005 Message (= ). Message Type LOG Severity WARNING Probable Cause Indicates that an unsupported operation has been requested. This is usually an internal Fabric OS problem or file corruption. The following is a possible value for function name and description of problem variable: fabsys_write: Unsupported write operation: process xxx In this value, xxx is the process ID (PID), which could be any whole number. Recommended Action Reboot or power cycle the active CP (for modular systems) or the switch (for single-board systems). If the message persists, run the firmwareDownload command to update the firmware. FABS-1006 Message : object unit . Message Type LOG Severity WARNING Probable Cause Indicates that there is no device in the slot with the specified object type ID in the system module record. This could indicate a serious Fabric OS data problem on the switch. The possible values for function name and description of problem variable are: • setSoftState: bad object • setSoftState: invalid type or unit • media_sync: Media oid mapping failed • fabsys_media_i2c_op: Media oid mapping failed • fabsys_media_i2c_op: obj is not media type • media_class_hndlr: failed sending media state to blade driver Recommended Action If the message is isolated, monitor the error messages on the switch. If the error is repetitive or if the fabric failed, failover or reboot the switch. If the message persists, run the firmwareDownload command to update the firmware. 322 Fabric OS Message Reference 53-1002749-01