Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 633

MFIC-1001 5 MFIC Messages MFIC-1001 Message failure at sysmod_scn registry rc= . Message Type LOG Severity ERROR Probable Cause Indicates the system is temporarily out of resources. Recommended Action No action is required; this message is often transitory. If the message persists, run the reboot or the haFailover command (if applicable). If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. MFIC-1002 Message Chassis FRU header not programmed for switch NID, using defaults (applies only to FICON environments). Message Type LOG Severity INFO Probable Cause Indicates that custom switch node descriptor (NID) fields have not been programmed in nonvolatile storage. The default values are used. The Switch NID is used only in the following SB ELS frames: Request Node Identification Data (RNID) and Registered Link Incident Record (RLIR). The use of SB-3 link incident registration and reporting is typically limited to FICON environments. Recommended Action No action is required if SB-3 link incident registration and reporting is not used by the host or if default values are desired for the switch node descriptor fields. MFIC-1003 Message Effective Insistent domain ID for the fabric changed from to . Message Type LOG Severity WARNING Probable Cause Indicates that one or more switches joined the fabric with an insistent domain ID (IDID) mode setting that is different from the current effective IDID mode for the fabric. This message also occurs when the IDID for the fabric has been turned on or off. The possible values for the state are "On" and "Off". Fabric OS Message Reference 611 53-1002749-01