Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 172

5 AUTH-1023 AUTH-1023 Message Failed to during : port . Message Type LOG Severity ERROR Probable Cause Indicates an authentication operation failed for a certain authentication phase. The Operation type varies depending on authentication type: • Some operations for Switch Link Authentication Protocol (SLAP): certificate retrieve, certificate verification, signature verification, or nonce signing. • Some operations for Fibre Channel Authentication Protocol (FCAP): certificate retrieve, certificate verification, signature verification, or nonce signing. • Some operations for Diffie Hellman - Challenge Handshake Authentication Protocol (DH-CHAP): response calculation, challenge generation, or secret retrieve. The authentication phase specifies which phase of a particular authentication protocol failed. A nonce is a single-use, usually random value used in authentication protocols to prevent replay attacks. Recommended Action The error may indicate that an invalid entity tried to connect to the switch. Check the connection port for a possible unauthorized access attack. It may indicate that the public key infrastructure (PKI) object for SLAP or FCAP or the secret value for DH-CHAP on the local entity is not set up properly. Reinstall all PKI objects or reset the secret value for DH-CHAP properly. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. AUTH-1025 Message Failed to get during : port . Message Type LOG Severity ERROR Probable Cause Indicates that the authentication process failed to get expected information during the specified authentication phase. Usually this problem is transient. The authentication may fail. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. 150 Fabric OS Message Reference 53-1002749-01