Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 308

5 EM-1035 Recommended Action Reseat the FRU. Execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade by using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the problem persists, replace the FRU. EM-1035 Message 2 circuit paired Power Supplies are faulty, please check the AC main switch/circuit to see if it has power. Message Type LOG Severity ERROR Probable Cause Indicates that both power supplies associated with one of the two main circuits are present but faulty, the circuit's switch may have been turned off, or the AC power source has been interrupted for that circuit. The Switch side value designates the circuit switch facing the cable side of the chassis, and is one of the following values: • left - Controls the odd-numbered power supply units. • right - Controls the even-numbered power supply units. Recommended Action Verify that the identified AC circuit switch is turned on, the power cord is properly attached and undamaged, and the power source is operating properly. EM-1036 Message is not accessible. Message Type LOG Severity WARNING Probable Cause Indicates that the specified field-replaceable unit (FRU) is not present on the switch. If the FRU is a World Wide Name (WWN) card, the default WWN and IP addresses are used for the switch. Recommended Action Reseat the FRU. If the problem persists, restart or power cycle the switch. Execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade by using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the problem still persists, replace the FRU. 286 Fabric OS Message Reference 53-1002749-01