Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 196

5 BL-1031 BL-1031 Message Link timeout in internal port (slot , port ) resulted in blade fault. Use slotpoweroff/slotpoweron to recover the blade. Message Type LOG Severity CRITICAL Probable Cause Indicates that link timeout occurred in one of the back-end internal ports. Recommended Action Power cycle the blade using the slotPowerOff and slotPowerOn commands. BL-1032 Message (slot ,bitmap 0x) ports never came up ONLINE (reason , state ). Disabling slot. Message Type LOG Severity CRITICAL Probable Cause Indicates that back-end (non-user) ports have not come online within the time limit. Recommended Action Execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the message persists, replace the blade. BL-1033 Message (slot ,bitmap 0x) No disable acknowledgment from ports (state ). Disabling slot. Message Type LOG Severity CRITICAL Probable Cause Indicates that the system has timed out waiting for the disable messages from the user ports after disabling the ports. Recommended Action Execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the message persists, replace the blade. 174 Fabric OS Message Reference 53-1002749-01