Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 382

5 FCR-1057 FCR-1057 Message EX_Port() incompatible long distance parameters on link. Message Type LOG Severity ERROR Probable Cause Indicates that the port, which is configured in long distance mode, has incompatible long distance parameters. Recommended Action Check the port configuration on both sides of the link using the portCfgShow command. Investigate the other switch for more details. Run the errShow command on the other switch to view the error log for additional messages. FCR-1058 Message Port isolated due to mismatched configuration parameter; . Message Type LOG Severity WARNING Probable Cause Indicates that the specified port was isolated after segmentation caused by mismatched configuration parameters or by a domain ID assigned by the principal switch that did not match the insistent domain ID of this port. Recommended Action Check the switches on both ends of the link for a possible mismatch in switch or port configuration parameters such as Operating Mode, E_D_TOV, R_A_TOV, Domain ID Offset, and so on. Run the portCfgExport command to modify the appropriate parameters on the local switch. Run the appropriate configuration command to modify the switch or port parameters on the remote switch. FCR-1059 Message EX_Port was disabled due to an authentication failure. Message Type LOG Severity INFO Probable Cause Indicates that the authentication, which uses the Diffie Hellman - Challenge Handshake Authentication Protocol (DH-CHAP), failed on the EX_Port. Recommended Action Verify that the shared secrets on both sides of the link match. Disable and enable the ports by using the portDisable and the portEnable commands to restart authentication. 360 Fabric OS Message Reference 53-1002749-01