Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 716

5 SEC-1031 SEC-1031 Message Current security policy DB cannot be supported by standby. CPs will go out of sync. Message Type LOG Severity WARNING Probable Cause Indicates the security database size is not supported by the standby control processor (CP). Recommended Action Reduce the security policy size by deleting entries within a policy or by deleting some policies. SEC-1032 Message Empty FCS list is not allowed. Message Type LOG Severity ERROR Probable Cause Indicates a corruption occurred during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) distributes the security database to the other switches in the fabric, and then local validation finds the error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database may not be correctly updated for that specific switch. SEC-1033 Message Invalid character used in member parameter to add switch to SCC policy; command terminated. Message Type LOG Severity ERROR Probable Cause Indicates a member parameter in the secPolicyAdd command is invalid (for example, it may include an invalid character, such as an asterisk). A valid switch identifier (a WWN, a domain ID, or a switch name) must be provided as a member parameter in the secPolicyAdd command. Only the secPolicyCreate command supports use of the asterisk for adding switches to policies. Recommended Action Run the secPolicyAdd command using a valid switch identifier (WWN, domain ID, or switch name) to add specific switches to the Switch Connection Control (SCC) policy. 694 Fabric OS Message Reference 53-1002749-01