Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 190

5 BL-1014 BL-1014 Message bport port int. is disabled. status=0x. Message Type LOG Severity ERROR Probable Cause Indicates that the port generated an excessive number of interrupts that may prove fatal to the switch operation. The port is disabled to prevent the control processor (CP) from becoming too busy. The bport number displayed in the message is the blade port; this number may not correspond to a user port number. Recommended Action Make sure to capture the console output during this process. On a bladed switch, execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. On a non-bladed switch, execute the reboot command to restart the switch. If there is a hardware error, the slotPowerOff or slotPowerOn fails on the bladed switch, or errors are encountered again, replace the blade or the (non-bladed) switch. BL-1015 Message bport port is faulted. status=0x. Message Type LOG Severity ERROR Probable Cause Indicates that the port generated an excessive number of interrupts that may prove fatal to the switch operation. The port is disabled to prevent the control processor (CP) from becoming too busy. The bport number displayed in the message is the blade port; this number may not correspond to a user port number. Recommended Action Make sure to capture the console output during this process. On a bladed switch, execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. On a non-bladed switch, execute the reboot command to restart the switch. If there is a hardware error, the slotPowerOff or slotPowerOn fails on the bladed switch, or errors are encountered again, replace the blade or the (non-bladed) switch. 168 Fabric OS Message Reference 53-1002749-01