Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 855

SULB-1010 5 TABLE 9 Upgrade state and code value (Continued) Upgrade state SUS_ACT_FWC_BEGIN SUS_PEER_RESTORE_BEGIN SUS_SBY_RESTORE_BEGIN SUS_PEER_FWC_BEGIN SUS_PEER_FS_CHECK1 SUS_FINISH SUS_COMMIT Code 0x2f 0x30 0x31 0x32 0x33 0x34 0x35 Recommended Action Run the firmwareDownloadStatus command for more information. In a modular switch, when the firmwareDownload command fails, the command will synchronize the firmware on the two partitions of each CP by starting a firmware commit operation. Wait until this operation completes (about 10 minutes) before attempting another firmware download. In a modular switch, when the firmwareDownload command fails, the two CPs may end up with different versions of firmware and they may not gain high availability (HA) sync. In this case, run the firmwareDownload -s command to upgrade the firmware on the standby CP to the same version as the active CP. Then retry the firmwareDownload command to download the desired version of firmware onto the CPs. Refer to the Fabric OS Troubleshooting Guide for troubleshooting information. SULB-1010 Message Firmwarecommit failed (status=0x). Message Type AUDIT | LOG Class FIRMWARE Severity INFO Probable Cause Indicates that the firmwareCommit command failed. The error code provides debugging information. Recommended Action If the failure is caused by an inconsistent filesystem, contact your switch service provider. SULB-1011 Message Firmwaredownload command failed. . Message Type LOG Severity INFO Probable Cause Indicates that the firmwareDownload command failed. The error string value indicates the reason for failure. Fabric OS Message Reference 833 53-1002749-01