Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 565

HAM-1006 5 HAM-1006 Message EMAC controller for Active CP is BAD. Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that the local Ethernet Media Access Controller (EMAC) on the active CP has been marked BAD as determined by the diagnostic test run by the high availability manager (HAM) module. Recommended Action The standby CP will take over and reset the active CP. The system will be non-redundant because the standby CP becomes the active CP. HAM-1007 Message Need to reboot the system for recovery, reason: . Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that the switch in current condition needs to be restarted to achieve a reliable recovery. The reasons can be one of the following: • The standby CP was not ready when failover occurred. • The failover occurred when the last logical switch (LS) transaction was incomplete. • The switch failed when timeout occurred at certain stage. • The cold or warm recovery has failed. Recommended Action If auto-reboot is enabled, the switch will automatically restart. Otherwise, execute the reboot command to manually restart the switch. HAM-1008 Message Rebooting the system for recovery - auto-reboot is enabled. Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that the recovery by auto-reboot is enabled, and therefore the switch automatically restarts. This message is displayed if the event logged in HAM-1007 has occurred and auto-reboot is enabled. Recommended Action Wait until the switch is up to perform any operations. Fabric OS Message Reference 543 53-1002749-01