Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 542

5 FW-1432 FW-1432 Message Switch status change contributing factor WWN: bad. Message Type LOG Severity WARNING Probable Cause Indicates that the switch is not in a healthy state. This occurred because the number of faulty World Wide Name (WWN) cards is greater than or equal to the policy set by the switchStatusPolicySet command. Recommended Action Replace the faulty WWN card. FW-1433 Message Switch status change contributing factor CP: CP non-redundant () faulty. Message Type LOG Severity WARNING Probable Cause Indicates that the switch is not in a healthy state. This occurred because the number of faulty CPs is greater than or equal to the policy set by the switchStatusPolicySet command. The CPs are not redundant. If you power cycle a chassis in dual-domain configuration, and then reset the micro-switch of the active CP before the heartbeat is up, this will cause both CPs to come up in a non-redundant state. Recommended Action Execute the firmwareShow command to verify if both the CPs have compatible firmware levels. Execute the firmwareDownload command to install the same level of firmware to both CPs. Replace any faulty CPs. If you reset the micro-switch (the latch on the CP blade) on the active CP before the heartbeat was up on a power cycle, and the CPs came up non-redundant, then you should reboot the CPs again to clear the problem. FW-1434 Message Switch status change contributing factor Blade: blade failures (). Message Type LOG Severity WARNING Probable Cause Indicates that the switch is not in a healthy state. This occurred because the number of blade failures is greater than or equal to the policy set by the switchStatusPolicySet command. Recommended Action Replace the faulty blade. 520 Fabric OS Message Reference 53-1002749-01