Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 229

CDR-1001 5 CDR Messages CDR-1001 Message Port port fault. Change the SFP or check cable. Message Type LOG Severity ERROR Probable Cause Indicates a deteriorated small form-factor pluggable (SFP) transceiver, an incompatible SFP transceiver pair, a faulty cable between the peer ports, or the port speed configuration does not match the capability of the SFP transceiver. Recommended Action Verify that compatible SFP transceivers are used on the peer ports, the SFP transceivers have not deteriorated, and the Fibre Channel cable is not faulty. Replace the SFP transceivers or the cable if necessary. CDR-1002 Message Port chip faulted due to internal error. Message Type LOG | FFDC Severity ERROR Probable Cause Indicates an internal error. All the ports on the blade or switch will be disrupted. Recommended Action To recover a bladed system, execute the slotPowerOff and slotPowerOn commands on the blade. To recover a non-bladed system, execute the fastBoot command on the switch. CDR-1003 Message S,C: HW ASIC Chip error type = 0x. If the problem persists, blade may need to be reset or replaced. Message Type LOG Severity WARNING Probable Cause Indicates an internal error in the application-specific integrated circuit (ASIC) hardware that may degrade the data traffic. Recommended Action Restart the system at the next maintenance window. If the problem persists, replace the blade. Fabric OS Message Reference 207 53-1002749-01