Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 871

SWCH-1019 5 SWCH-1019 Message Device tries to FLOGI, reject FLOGI as persistent PID is set on device and port has user area bound to it. Message Type LOG Severity INFO Probable Cause Indicates a WWN-PID and port address binding collision. Recommended Action The persistent PID is set on the device and the requested area cannot be assigned because the port it is trying to log in through has a different area bound to it. Remove the WWN-PID binding using the wwnaddress --unbind command or remove the port address binding using the portaddress --unbind command and then re-enable the port. SWCH-1020 Message HA state out of sync: Standby CP (ver = ) does not support QoS links to AG(Active CP version = ). Message Type LOG Severity WARNING Probable Cause Indicates that the standby control processor (CP) does not support links to Access Gateway running quality of service (QoS). Recommended Action Load a firmware version on the standby CP that supports QoS links to Access Gateway by using the firmwareDownload command. SWCH-1021 Message HA state out of sync: Standby CP (ver = ) does not support Dynamic area on default switch (Active CP version = ). Message Type LOG Severity WARNING Probable Cause Indicates that the standby control processor (CP) does not support dynamic area on the default switch. Recommended Action Load a firmware version on the standby CP that supports dynamic area on the default switch by using the firmwareDownload command. Fabric OS Message Reference 849 53-1002749-01