Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 221

C3-1018 5 C3-1018 Message Link reset threshold value exceeded in the link S,P(). Message Type LOG Severity ERROR Probable Cause Indicates that the specified blade is faulted because the link reset threshold value has exceeded. Recommended Action When this error is observed persistently, power cycle the specified blade using the slotPowerOff and slotPowerOn commands. If the problem persists, replace the blade. C3-1019 Message S,C: HW ASIC Chip TXQ FID parity error threshold reached type = 0x. Message Type LOG Severity WARNING Probable Cause Indicates that an internal error is observed in the application-specific integrated circuit (ASIC) hardware that may degrade the data traffic. Recommended Action Restart the system at the next maintenance window. C3-1020 Message S,P(): Some non-critical CRC with good EOF errors were observed: current:0x, last:0x thresh1:0x. Message Type LOG Severity WARNING Probable Cause Indicates that some non-critical errors were detected in the hardware. Recommended Action No action is required. Fabric OS Message Reference 199 53-1002749-01